| 12345678910111213141516171819202122232425262728293031 |
- *****************************************************************************
- ** ChibiOS/NIL port for Atmel AVR ATTiny167. **
- *****************************************************************************
- ** TARGET **
- The demo runs on a Digispark Pro board based on an ATtiny167.
- ** The Demo **
- A thread is used to print a message to the UART. The UART pins, must be
- connected to an FTDI converter to see the message on a computer. The thread
- also toggles the onboard test/status LED every second, the LED is connected
- to the PB1 pin of the ATtiny167 MCU wich corresponds to P1 on the
- Digispark Pro board.
- ** Build Procedure **
- The demo was built using the GCC AVR toolchain.
- It should build with WinAVR too!
- Just run the command "make" to build this example.
- ** Programming procedure **
- The ATtiny167 is pre-programmed with a bootloader.
- Thus it can act as an USB device.
- The Digispark Pro runs the “micronucleus” bootloader.
- This bootloader comes with a command line tool which can be used to
- program the board.
- Form more details, look at the Makefile or the github repository:
- https://github.com/micronucleus/micronucleus
|
