danny wang
a136536ff5
watchrobot first commit
|
%!s(int64=2) %!d(string=hai) anos | |
|---|---|---|
| .. | ||
| Makefile | %!s(int64=2) %!d(string=hai) anos | |
| chconf.h | %!s(int64=2) %!d(string=hai) anos | |
| halconf.h | %!s(int64=2) %!d(string=hai) anos | |
| main.c | %!s(int64=2) %!d(string=hai) anos | |
| mcuconf.h | %!s(int64=2) %!d(string=hai) anos | |
| readme.txt | %!s(int64=2) %!d(string=hai) anos | |
readme.txt
*****************************************************************************
** ChibiOS/NIL port for Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The demo runs on an Arduino Mega board.
** The Demo **
One thread prints a message to the serial console, which is available on
the board USB connector (FT232 converter).
Another thread toggles the LED on PB7 (pin 13 on Arduino IDE) every 500ms.
** Build Procedure **
The demo was built using the GCC AVR toolchain. It should build with WinAVR too!
** Notes **
This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.
** ChibiOS/NIL port for Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The demo runs on an Arduino Mega board.
** The Demo **
One thread prints a message to the serial console, which is available on
the board USB connector (FT232 converter).
Another thread toggles the LED on PB7 (pin 13 on Arduino IDE) every 500ms.
** Build Procedure **
The demo was built using the GCC AVR toolchain. It should build with WinAVR too!
** Notes **
This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.