| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970 |
- # hwdef for bootloader for CubeYellow
- # MCU class and specific type
- MCU STM32F7xx STM32F777xx
- # crystal frequency
- OSCILLATOR_HZ 24000000
- define STM32_LSECLK 32768U
- define STM32_LSEDRV (3U << 3U)
- define STM32_PLLSRC STM32_PLLSRC_HSE
- define STM32_PLLM_VALUE 24
- define STM32_PLLN_VALUE 432
- define STM32_PLLP_VALUE 2
- define STM32_PLLQ_VALUE 9
- # board ID for firmware load
- APJ_BOARD_ID 120
- # board voltage
- STM32_VDD 330U
- # flash size
- FLASH_SIZE_KB 2048
- # USB setup
- USB_VENDOR 0x2DAE # ONLY FOR USE BY ProfiCNC / HEX! NOBODY ELSE
- USB_PRODUCT 0x1002
- USB_STRING_MANUFACTURER "Hex/ProfiCNC"
- USB_STRING_PRODUCT "CubeYellow-BL"
- USB_STRING_SERIAL "%SERIAL%"
- # order of UARTs (and USB)
- UART_ORDER OTG1 USART2 USART3 UART7
- PD5 USART2_TX USART2
- PD6 USART2_RX USART2
- PD3 USART2_CTS USART2
- PD4 USART2_RTS USART2
- # the telem2 USART, also with RTS/CTS available
- # USART3 serial3 telem2
- PD8 USART3_TX USART3
- PD9 USART3_RX USART3
- PD11 USART3_CTS USART3
- PD12 USART3_RTS USART3
- PE7 UART7_RX UART7
- PE8 UART7_TX UART7
- # Pin for PWM Voltage Selection
- PB4 PWM_VOLT_SEL OUTPUT HIGH
- # now we define the pins that USB is connected on
- PA11 OTG_FS_DM OTG1
- PA12 OTG_FS_DP OTG1
- # these are the pins for SWD debugging with a STlinkv2 or black-magic probe
- PA13 JTMS-SWDIO SWD
- PA14 JTCK-SWCLK SWD
- # no reserved flash for bootloader
- FLASH_RESERVE_START_KB 0
- # start on 4th sector (1st sector for bootloader, 2 for extra storage)
- FLASH_BOOTLOADER_LOAD_KB 96
- define HAL_USE_EMPTY_STORAGE 1
- define HAL_STORAGE_SIZE 16384
|
