123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135 |
- /*
- This program is free software: you can redistribute it and/or modify
- it under the terms of the GNU General Public License as published by
- the Free Software Foundation, either version 3 of the License, or
- (at your option) any later version.
- This program is distributed in the hope that it will be useful,
- but WITHOUT ANY WARRANTY; without even the implied warranty of
- MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
- GNU General Public License for more details.
- You should have received a copy of the GNU General Public License
- along with this program. If not, see <http://www.gnu.org/licenses/>.
- */
- /*
- DEVO Telemetry library
- */
- #define DEVOM_SYNC_BYTE 0xAA
- #define AP_SERIALMANAGER_DEVO_TELEM_BAUD 38400
- #define AP_SERIALMANAGER_DEVO_BUFSIZE_RX 0
- #define AP_SERIALMANAGER_DEVO_BUFSIZE_TX 32
- #include "AP_Devo_Telem.h"
- #include <AP_AHRS/AP_AHRS.h>
- #include <AP_GPS/AP_GPS.h>
- #include <AP_BattMonitor/AP_BattMonitor.h>
- #include <GCS_MAVLink/GCS.h>
- extern const AP_HAL::HAL& hal;
- void AP_DEVO_Telem::init()
- {
- const AP_SerialManager& serial_manager = AP::serialmanager();
- // check for DEVO_DPort
- if ((_port = serial_manager.find_serial(AP_SerialManager::SerialProtocol_Devo_Telem, 0))) {
- _port->set_flow_control(AP_HAL::UARTDriver::FLOW_CONTROL_DISABLE);
- // initialise uart
- _port->begin(AP_SERIALMANAGER_DEVO_TELEM_BAUD, AP_SERIALMANAGER_DEVO_BUFSIZE_RX, AP_SERIALMANAGER_DEVO_BUFSIZE_TX);
- hal.scheduler->register_io_process(FUNCTOR_BIND_MEMBER(&AP_DEVO_Telem::tick, void));
- }
- }
- uint32_t AP_DEVO_Telem::gpsDdToDmsFormat(float ddm)
- {
- int32_t deg = (int32_t)ddm;
- float mm = (ddm - deg) * 60.0f;
- mm = ((float)deg * 100.0f + mm) /100.0f;
- if ((mm < -180.0f) || (mm > 180.0f)) {
- mm = 0.0f;
- }
- return mm * 1.0e7f;
- }
- /*
- send_frames - sends updates down telemetry link
- should be called at 1hz
- */
- #define DEVO_SPEED_FACTOR 0.0194384f
- void AP_DEVO_Telem::send_frames()
- {
- // return immediately if not initialised
- if (_port == nullptr) {
- return;
- }
- struct PACKED {
- uint8_t header; ///< 0xAA for a valid packet
- int32_t lon;
- int32_t lat;
- int32_t alt;
- int16_t speed;
- int16_t temp;
- int16_t volt;
- uint8_t checksum8;
- } devoPacket{};
- devoPacket.header = DEVOM_SYNC_BYTE;
- const AP_AHRS &_ahrs = AP::ahrs();
- const AP_GPS &gps = AP::gps();
- Location loc;
- if (_ahrs.get_position(loc)) {
- devoPacket.lat = gpsDdToDmsFormat(loc.lat);
- devoPacket.lon = gpsDdToDmsFormat(loc.lng);
- devoPacket.speed = (int16_t)(gps.ground_speed() * DEVO_SPEED_FACTOR * 100.0f); // * 100 for cm
- /*
- Note that this isn't actually barometric altitude, it is the
- inertial nav estimate of altitude above home.
- */
- float alt;
- _ahrs.get_relative_position_D_home(alt);
- devoPacket.alt = alt * -100.0f; // coordinates was in NED, so it needs to change sign. Protocol requires in cm!
- }
- devoPacket.volt = roundf(AP::battery().voltage() * 10.0f);
- devoPacket.temp = gcs().custom_mode(); // Send mode as temperature
- // emit the packet to the port byte-by-byte, calculating checksum
- // as we go. Note we are stepping backwards through the structure
- // - presumably to get endianness correct on the entries!
- uint8_t *b = (uint8_t *)&devoPacket;
- for (uint8_t i = sizeof(devoPacket)-1; i !=0; i--) {
- _port->write(b, 1);
- devoPacket.checksum8 += *b++; // Add Checksum
- }
- _port->write(&devoPacket.checksum8, 1);
- }
- void AP_DEVO_Telem::tick(void)
- {
- uint32_t now = AP_HAL::millis();
- if (now - _last_frame_ms > 1000) {
- _last_frame_ms = now;
- send_frames();
- }
- }
|