danny wang
6b2cb6fa39
this N3 net clean robot use bfd1.5V6
|
2 anni fa | |
|---|---|---|
| .. | ||
| Makefile | 2 anni fa | |
| chconf.h | 2 anni fa | |
| halconf.h | 2 anni fa | |
| main.c | 2 anni fa | |
| mcuconf.h | 2 anni fa | |
| readme.txt | 2 anni fa | |
readme.txt
*****************************************************************************
** ChibiOS/NIL port for Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The demo runs on an Arduino Mega board.
** The Demo **
One thread prints a message to the serial console, which is available on
the board USB connector (FT232 converter).
Another thread toggles the LED on PB7 (pin 13 on Arduino IDE) every 500ms.
** Build Procedure **
The demo was built using the GCC AVR toolchain. It should build with WinAVR too!
** Notes **
This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.
** ChibiOS/NIL port for Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The demo runs on an Arduino Mega board.
** The Demo **
One thread prints a message to the serial console, which is available on
the board USB connector (FT232 converter).
Another thread toggles the LED on PB7 (pin 13 on Arduino IDE) every 500ms.
** Build Procedure **
The demo was built using the GCC AVR toolchain. It should build with WinAVR too!
** Notes **
This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.