danny wang
6b2cb6fa39
this N3 net clean robot use bfd1.5V6
|
před 2 roky | |
|---|---|---|
| .. | ||
| Makefile | před 2 roky | |
| chconf.h | před 2 roky | |
| halconf.h | před 2 roky | |
| main.c | před 2 roky | |
| mcuconf.h | před 2 roky | |
| readme.txt | před 2 roky | |
readme.txt
*****************************************************************************
** ChibiOS/NIL port for Atmel AVR ATTiny167. **
*****************************************************************************
** TARGET **
The demo runs on a Digispark Pro board based on an ATtiny167.
** The Demo **
A thread is used to print a message to the UART. The UART pins, must be
connected to an FTDI converter to see the message on a computer. The thread
also toggles the onboard test/status LED every second, the LED is connected
to the PB1 pin of the ATtiny167 MCU wich corresponds to P1 on the
Digispark Pro board.
** Build Procedure **
The demo was built using the GCC AVR toolchain.
It should build with WinAVR too!
Just run the command "make" to build this example.
** Programming procedure **
The ATtiny167 is pre-programmed with a bootloader.
Thus it can act as an USB device.
The Digispark Pro runs the “micronucleus” bootloader.
This bootloader comes with a command line tool which can be used to
program the board.
Form more details, look at the Makefile or the github repository:
https://github.com/micronucleus/micronucleus
** ChibiOS/NIL port for Atmel AVR ATTiny167. **
*****************************************************************************
** TARGET **
The demo runs on a Digispark Pro board based on an ATtiny167.
** The Demo **
A thread is used to print a message to the UART. The UART pins, must be
connected to an FTDI converter to see the message on a computer. The thread
also toggles the onboard test/status LED every second, the LED is connected
to the PB1 pin of the ATtiny167 MCU wich corresponds to P1 on the
Digispark Pro board.
** Build Procedure **
The demo was built using the GCC AVR toolchain.
It should build with WinAVR too!
Just run the command "make" to build this example.
** Programming procedure **
The ATtiny167 is pre-programmed with a bootloader.
Thus it can act as an USB device.
The Digispark Pro runs the “micronucleus” bootloader.
This bootloader comes with a command line tool which can be used to
program the board.
Form more details, look at the Makefile or the github repository:
https://github.com/micronucleus/micronucleus