danny wang
6b2cb6fa39
this N3 net clean robot use bfd1.5V6
|
%!s(int64=2) %!d(string=hai) anos | |
|---|---|---|
| .. | ||
| Makefile | %!s(int64=2) %!d(string=hai) anos | |
| chconf.h | %!s(int64=2) %!d(string=hai) anos | |
| halconf.h | %!s(int64=2) %!d(string=hai) anos | |
| main.c | %!s(int64=2) %!d(string=hai) anos | |
| mcuconf.h | %!s(int64=2) %!d(string=hai) anos | |
| readme.txt | %!s(int64=2) %!d(string=hai) anos | |
readme.txt
*****************************************************************************
** ChibiOS/RT port for Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The demo runs on an Arduino Mega board.
** The Demo **
This demo creates a continuous timer which expires every 500ms, running a
callback function that toggles the LED on PB7. It also prints out the values
of the timer registers on the first serial port.
** Build Procedure **
The demo was built using the GCC AVR toolchain. It should build with WinAVR too!
** Notes **
This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.
** ChibiOS/RT port for Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The demo runs on an Arduino Mega board.
** The Demo **
This demo creates a continuous timer which expires every 500ms, running a
callback function that toggles the LED on PB7. It also prints out the values
of the timer registers on the first serial port.
** Build Procedure **
The demo was built using the GCC AVR toolchain. It should build with WinAVR too!
** Notes **
This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.