danny wang
6b2cb6fa39
this N3 net clean robot use bfd1.5V6
|
há 2 anos atrás | |
|---|---|---|
| .. | ||
| Makefile | há 2 anos atrás | |
| chconf.h | há 2 anos atrás | |
| halconf.h | há 2 anos atrás | |
| main.c | há 2 anos atrás | |
| mcuconf.h | há 2 anos atrás | |
| readme.txt | há 2 anos atrás | |
readme.txt
*****************************************************************************
** ChibiOS/RT ADC test on Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The test demo runs on an Arduino Mega board.
** The Demo **
This test blinks the onboard LED and also prints the result of the ADC
conversion to the Serial0. A voltmeter can be use to compare the printed
value to the value on pin A0 of the arduino board. To make this test, a
potentiometer is connected to the pin A0 of the board.
** Build Procedure **
The demo was built using the GCC AVR toolchain.
** ChibiOS/RT ADC test on Atmel AVR ATmega2560. **
*****************************************************************************
** TARGET **
The test demo runs on an Arduino Mega board.
** The Demo **
This test blinks the onboard LED and also prints the result of the ADC
conversion to the Serial0. A voltmeter can be use to compare the printed
value to the value on pin A0 of the arduino board. To make this test, a
potentiometer is connected to the pin A0 of the board.
** Build Procedure **
The demo was built using the GCC AVR toolchain.