/** ****************************************************************************** * @file stm32f4xx_dcmi.h * @author MCD Application Team * @version V1.8.0 * @date 04-November-2016 * @brief This file contains all the functions prototypes for the DCMI firmware library. ****************************************************************************** * @attention * *

© COPYRIGHT 2016 STMicroelectronics

* * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); * You may not use this file except in compliance with the License. * You may obtain a copy of the License at: * * http://www.st.com/software_license_agreement_liberty_v2 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. * ****************************************************************************** */ /* Define to prevent recursive inclusion -------------------------------------*/ #ifndef __STM32F4xx_DCMI_H #define __STM32F4xx_DCMI_H #ifdef __cplusplus extern "C" { #endif /* Includes ------------------------------------------------------------------*/ #include "stm32f4xx.h" /** @addtogroup STM32F4xx_StdPeriph_Driver * @{ */ /** @addtogroup DCMI * @{ */ /* Exported types ------------------------------------------------------------*/ /** * @brief DCMI Init structure definition */ typedef struct { uint16_t DCMI_CaptureMode; /*!< Specifies the Capture Mode: Continuous or Snapshot. This parameter can be a value of @ref DCMI_Capture_Mode */ uint16_t DCMI_SynchroMode; /*!< Specifies the Synchronization Mode: Hardware or Embedded. This parameter can be a value of @ref DCMI_Synchronization_Mode */ uint16_t DCMI_PCKPolarity; /*!< Specifies the Pixel clock polarity: Falling or Rising. This parameter can be a value of @ref DCMI_PIXCK_Polarity */ uint16_t DCMI_VSPolarity; /*!< Specifies the Vertical synchronization polarity: High or Low. This parameter can be a value of @ref DCMI_VSYNC_Polarity */ uint16_t DCMI_HSPolarity; /*!< Specifies the Horizontal synchronization polarity: High or Low. This parameter can be a value of @ref DCMI_HSYNC_Polarity */ uint16_t DCMI_CaptureRate; /*!< Specifies the frequency of frame capture: All, 1/2 or 1/4. This parameter can be a value of @ref DCMI_Capture_Rate */ uint16_t DCMI_ExtendedDataMode; /*!< Specifies the data width: 8-bit, 10-bit, 12-bit or 14-bit. This parameter can be a value of @ref DCMI_Extended_Data_Mode */ } DCMI_InitTypeDef; /** * @brief DCMI CROP Init structure definition */ typedef struct { uint16_t DCMI_VerticalStartLine; /*!< Specifies the Vertical start line count from which the image capture will start. This parameter can be a value between 0x00 and 0x1FFF */ uint16_t DCMI_HorizontalOffsetCount; /*!< Specifies the number of pixel clocks to count before starting a capture. This parameter can be a value between 0x00 and 0x3FFF */ uint16_t DCMI_VerticalLineCount; /*!< Specifies the number of lines to be captured from the starting point. This parameter can be a value between 0x00 and 0x3FFF */ uint16_t DCMI_CaptureCount; /*!< Specifies the number of pixel clocks to be captured from the starting point on the same line. This parameter can be a value between 0x00 and 0x3FFF */ } DCMI_CROPInitTypeDef; /** * @brief DCMI Embedded Synchronisation CODE Init structure definition */ typedef struct { uint8_t DCMI_FrameStartCode; /*!< Specifies the code of the frame start delimiter. */ uint8_t DCMI_LineStartCode; /*!< Specifies the code of the line start delimiter. */ uint8_t DCMI_LineEndCode; /*!< Specifies the code of the line end delimiter. */ uint8_t DCMI_FrameEndCode; /*!< Specifies the code of the frame end delimiter. */ } DCMI_CodesInitTypeDef; /* Exported constants --------------------------------------------------------*/ /** @defgroup DCMI_Exported_Constants * @{ */ /** @defgroup DCMI_Capture_Mode * @{ */ #define DCMI_CaptureMode_Continuous ((uint16_t)0x0000) /*!< The received data are transferred continuously into the destination memory through the DMA */ #define DCMI_CaptureMode_SnapShot ((uint16_t)0x0002) /*!< Once activated, the interface waits for the start of frame and then transfers a single frame through the DMA */ #define IS_DCMI_CAPTURE_MODE(MODE)(((MODE) == DCMI_CaptureMode_Continuous) || \ ((MODE) == DCMI_CaptureMode_SnapShot)) /** * @} */ /** @defgroup DCMI_Synchronization_Mode * @{ */ #define DCMI_SynchroMode_Hardware ((uint16_t)0x0000) /*!< Hardware synchronization data capture (frame/line start/stop) is synchronized with the HSYNC/VSYNC signals */ #define DCMI_SynchroMode_Embedded ((uint16_t)0x0010) /*!< Embedded synchronization data capture is synchronized with synchronization codes embedded in the data flow */ #define IS_DCMI_SYNCHRO(MODE)(((MODE) == DCMI_SynchroMode_Hardware) || \ ((MODE) == DCMI_SynchroMode_Embedded)) /** * @} */ /** @defgroup DCMI_PIXCK_Polarity * @{ */ #define DCMI_PCKPolarity_Falling ((uint16_t)0x0000) /*!< Pixel clock active on Falling edge */ #define DCMI_PCKPolarity_Rising ((uint16_t)0x0020) /*!< Pixel clock active on Rising edge */ #define IS_DCMI_PCKPOLARITY(POLARITY)(((POLARITY) == DCMI_PCKPolarity_Falling) || \ ((POLARITY) == DCMI_PCKPolarity_Rising)) /** * @} */ /** @defgroup DCMI_VSYNC_Polarity * @{ */ #define DCMI_VSPolarity_Low ((uint16_t)0x0000) /*!< Vertical synchronization active Low */ #define DCMI_VSPolarity_High ((uint16_t)0x0080) /*!< Vertical synchronization active High */ #define IS_DCMI_VSPOLARITY(POLARITY)(((POLARITY) == DCMI_VSPolarity_Low) || \ ((POLARITY) == DCMI_VSPolarity_High)) /** * @} */ /** @defgroup DCMI_HSYNC_Polarity * @{ */ #define DCMI_HSPolarity_Low ((uint16_t)0x0000) /*!< Horizontal synchronization active Low */ #define DCMI_HSPolarity_High ((uint16_t)0x0040) /*!< Horizontal synchronization active High */ #define IS_DCMI_HSPOLARITY(POLARITY)(((POLARITY) == DCMI_HSPolarity_Low) || \ ((POLARITY) == DCMI_HSPolarity_High)) /** * @} */ /** @defgroup DCMI_Capture_Rate * @{ */ #define DCMI_CaptureRate_All_Frame ((uint16_t)0x0000) /*!< All frames are captured */ #define DCMI_CaptureRate_1of2_Frame ((uint16_t)0x0100) /*!< Every alternate frame captured */ #define DCMI_CaptureRate_1of4_Frame ((uint16_t)0x0200) /*!< One frame in 4 frames captured */ #define IS_DCMI_CAPTURE_RATE(RATE) (((RATE) == DCMI_CaptureRate_All_Frame) || \ ((RATE) == DCMI_CaptureRate_1of2_Frame) ||\ ((RATE) == DCMI_CaptureRate_1of4_Frame)) /** * @} */ /** @defgroup DCMI_Extended_Data_Mode * @{ */ #define DCMI_ExtendedDataMode_8b ((uint16_t)0x0000) /*!< Interface captures 8-bit data on every pixel clock */ #define DCMI_ExtendedDataMode_10b ((uint16_t)0x0400) /*!< Interface captures 10-bit data on every pixel clock */ #define DCMI_ExtendedDataMode_12b ((uint16_t)0x0800) /*!< Interface captures 12-bit data on every pixel clock */ #define DCMI_ExtendedDataMode_14b ((uint16_t)0x0C00) /*!< Interface captures 14-bit data on every pixel clock */ #define IS_DCMI_EXTENDED_DATA(DATA)(((DATA) == DCMI_ExtendedDataMode_8b) || \ ((DATA) == DCMI_ExtendedDataMode_10b) ||\ ((DATA) == DCMI_ExtendedDataMode_12b) ||\ ((DATA) == DCMI_ExtendedDataMode_14b)) /** * @} */ /** @defgroup DCMI_interrupt_sources * @{ */ #define DCMI_IT_FRAME ((uint16_t)0x0001) #define DCMI_IT_OVF ((uint16_t)0x0002) #define DCMI_IT_ERR ((uint16_t)0x0004) #define DCMI_IT_VSYNC ((uint16_t)0x0008) #define DCMI_IT_LINE ((uint16_t)0x0010) #define IS_DCMI_CONFIG_IT(IT) ((((IT) & (uint16_t)0xFFE0) == 0x0000) && ((IT) != 0x0000)) #define IS_DCMI_GET_IT(IT) (((IT) == DCMI_IT_FRAME) || \ ((IT) == DCMI_IT_OVF) || \ ((IT) == DCMI_IT_ERR) || \ ((IT) == DCMI_IT_VSYNC) || \ ((IT) == DCMI_IT_LINE)) /** * @} */ /** @defgroup DCMI_Flags * @{ */ /** * @brief DCMI SR register */ #define DCMI_FLAG_HSYNC ((uint16_t)0x2001) #define DCMI_FLAG_VSYNC ((uint16_t)0x2002) #define DCMI_FLAG_FNE ((uint16_t)0x2004) /** * @brief DCMI RISR register */ #define DCMI_FLAG_FRAMERI ((uint16_t)0x0001) #define DCMI_FLAG_OVFRI ((uint16_t)0x0002) #define DCMI_FLAG_ERRRI ((uint16_t)0x0004) #define DCMI_FLAG_VSYNCRI ((uint16_t)0x0008) #define DCMI_FLAG_LINERI ((uint16_t)0x0010) /** * @brief DCMI MISR register */ #define DCMI_FLAG_FRAMEMI ((uint16_t)0x1001) #define DCMI_FLAG_OVFMI ((uint16_t)0x1002) #define DCMI_FLAG_ERRMI ((uint16_t)0x1004) #define DCMI_FLAG_VSYNCMI ((uint16_t)0x1008) #define DCMI_FLAG_LINEMI ((uint16_t)0x1010) #define IS_DCMI_GET_FLAG(FLAG) (((FLAG) == DCMI_FLAG_HSYNC) || \ ((FLAG) == DCMI_FLAG_VSYNC) || \ ((FLAG) == DCMI_FLAG_FNE) || \ ((FLAG) == DCMI_FLAG_FRAMERI) || \ ((FLAG) == DCMI_FLAG_OVFRI) || \ ((FLAG) == DCMI_FLAG_ERRRI) || \ ((FLAG) == DCMI_FLAG_VSYNCRI) || \ ((FLAG) == DCMI_FLAG_LINERI) || \ ((FLAG) == DCMI_FLAG_FRAMEMI) || \ ((FLAG) == DCMI_FLAG_OVFMI) || \ ((FLAG) == DCMI_FLAG_ERRMI) || \ ((FLAG) == DCMI_FLAG_VSYNCMI) || \ ((FLAG) == DCMI_FLAG_LINEMI)) #define IS_DCMI_CLEAR_FLAG(FLAG) ((((FLAG) & (uint16_t)0xFFE0) == 0x0000) && ((FLAG) != 0x0000)) /** * @} */ /** * @} */ /* Exported macro ------------------------------------------------------------*/ /* Exported functions --------------------------------------------------------*/ /* Function used to set the DCMI configuration to the default reset state ****/ void DCMI_DeInit(void); /* Initialization and Configuration functions *********************************/ void DCMI_Init(DCMI_InitTypeDef* DCMI_InitStruct); void DCMI_StructInit(DCMI_InitTypeDef* DCMI_InitStruct); void DCMI_CROPConfig(DCMI_CROPInitTypeDef* DCMI_CROPInitStruct); void DCMI_CROPCmd(FunctionalState NewState); void DCMI_SetEmbeddedSynchroCodes(DCMI_CodesInitTypeDef* DCMI_CodesInitStruct); void DCMI_JPEGCmd(FunctionalState NewState); /* Image capture functions ****************************************************/ void DCMI_Cmd(FunctionalState NewState); void DCMI_CaptureCmd(FunctionalState NewState); uint32_t DCMI_ReadData(void); /* Interrupts and flags management functions **********************************/ void DCMI_ITConfig(uint16_t DCMI_IT, FunctionalState NewState); FlagStatus DCMI_GetFlagStatus(uint16_t DCMI_FLAG); void DCMI_ClearFlag(uint16_t DCMI_FLAG); ITStatus DCMI_GetITStatus(uint16_t DCMI_IT); void DCMI_ClearITPendingBit(uint16_t DCMI_IT); #ifdef __cplusplus } #endif #endif /*__STM32F4xx_DCMI_H */ /** * @} */ /** * @} */ /************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/